programming locations and options available in the 4,6 and 8 models are NOT identical If you have an NX-4 or 6 - DOUBLE CHECK YOUR MANUAL. The programming locations and values listed below ARE SPECIFIC TO THE NX-8. You do not need to create a loop or attach a resistor from the AUX terminal to any other terminal of the NX-8V panel !! Attach one jumper wire per Konnected Zone to one of the AUX outputs.

NOTE - you do not need EOL resistors on the AUX outputs for Konnected to read them. To save you time, I am writing down my configuration as an example you can copy. I spent hours troubleshooting and experimenting with settings needed. I’ll have to look into that.UPDATE - AUX Outputs on Interlogix GE Networx NX-8V DOES work The basic premise is not much different than the wireless firefighter unit which monitors for the audio of interconnected devices, but may differ due to supervision capability in the firefighter or the fact it does not physically tie into the circuit. I think due to UL, the manufacturer instructs users not to do it. I believe it is still within fire code to do so (use the relay) but you would need to check with your local authority. Under UL certification, monitored smokes have different requirements than non-monitored, so there are two separate certifications.

Instead it is for non-monitored sirens, alerting devices, etc.

The manufacturer recommendation is to not use the SM120X for a series of smokes and an Alarm control panel. If more than one smoke detector is in the circuit, using builder provided 120VAC smokes, there is no way of telling which tripped. See the attached capture from the manual. In the meantime, why? Why put in one orphan detector when there’s a whole interconnected loop which could just have a relay to connect to the control panel?įrom what I understand, this is likely due to UL and manufacturer.

Ge networx nx8v2